txili SG I know the brand loctite , but what thing I have to glue?the neddles? thanks again and sorry for my english. anotherthing, remove the needles , manually ?
Jirka SG Hi I have problem, my EFI lamp is ON now (only in low rpm is off) What can be wrong? I checked pump, but I didn`t find fault. There are only 2 wires for pump = power supply and 2 wires for level. Has injector feedback about pressure of fuel for diagnostic? Thanks for ideas
senator_brest SG Hi I'm from Belarus I have a problems with my piaggio x9 250cc '00 K05: Engine Temp gauge always stays at HI K06: Fuel Level gauge always stays at FULL K07: Air Temp always stays at 97 deg C.
Jirka SG Originally posted by X9_panel: [b]How to check the EFI signal - X9-500cc S08: EFI- Fuel injection warning lamp ( 250 & 500 cc ) This digidash is only to display the EFI signal - simple indication lamp. So you have to check the sensor side. This senor is providing the ON/OFF switch i.e. ON/OFF status It is using negative logic. Normal state : 12V sending to digidash = EFI Lamp OFF Warning state : 0 V = EFI Lamp ON for example, if the sensor is disconnected then EFI Lamp is ON Hopefully, this may help you to understand how to troubleshoot. [email protected][/b]
Jirka SG Thanks, but it doesn`t solve my problem. My display is OK. EFI lamp can be ON or OFF. low rpm is OFF it means ok (lower than 1000) Over 1000 is ON. But why?? How can i checked injector or pressure switch (if exist) or what everything can light on this lamp? (damper, valve possition...)
txili SG check with your mech-man y dont understand it, what is mech man? a picture whit the problem. [img=http://img254.imageshack.us/img254/9530/p1010012bc3.th.jpg]
