bbdc pratical test

n0s SG

would like to check with u all my test is on july 1st at bbdc heard they say those learning E model car exi will change to V model cal VTI
but i learn from the start is all the way EXI. will they give mi a exi on my test day or vti coz vti has diff turning point?

ditzy SG

No need to worry. Its just the engine make. Laughing I doubt that makes much of a difference when it comes to handling. Unless you're going to tell me a the more powerful car will make you turn wider because you never slow down enough.

n0s SG

both car oso gt drove b4 but then the vertical parking for both cars gt diff in the cicuit tat y need to comfirm if not on test date u learn E and v turning they teach u diff

the Bear SG

it's the driver, not the equipment Laughing

lucidol SG

siao liao! i learning EXI all the way too, going to book test in end July, the parking really different ah?? realli siao liao

^VioS^ SG

When parking, is the upper demister wire located higher or lower in the newer model? Or issit the same location...have to adjust yr reference points when u do reverse parallel/vertical parking if so Confused

digicharat SG

if you can drive... any model also make no difference...
if just because change model and you fail.... then you better dun drive.

spikedoll SG

u r just feeling worried and nervous due to change of model..nothing to do with da will cause parking differently...dun worry Smile

sunnyMAN SG

As a 'L plate driver' the only concern for usage of diff cars should be the sensitivity of the clutch, brakes, accel pedal, the stiffness of the steering, and probably the 'tightness ratio' of the handbrakes. The rest I dont think you will feel a difference when you are

1) travelling < 50kmh most of the time. At most 70kmh
2) Doing gear change at rpm of at most 3000-4000

You should be more concerned with driving techniques. Demister lines and dimensions are mostly the same. (You wun be able to tell the difference!!)

Good Luck Smile

pisces8 SG

Mr. Green